How to install.
About two minutes. You don't unscrew anything and you don't touch any wires: the cover goes on top of the switch or socket you already have.
Step by step
Why it works
- The cover sits on your frame, not on the key. Inside it is hollow, so the key underneath keeps rocking freely.
- The lever is the key's new handle. It is glued to the middle of the key and comes out through the slot. Press it up or down, and the key switches like before.
- It fits because it is made for your frame. The cover is made to your width and height with a 0.4 mm gap per side, so it holds by friction. Its depth is your measured D plus 5 mm, which leaves room for the key to move.
Can't find the middle of the key? Do it the other way round. Stick the tape on the flat part of the lever, push the lever's stick through the slot from inside the cover, then push the cover onto the frame. The lever lands exactly where it should. Press the stick for 30 seconds.
Taking it off
Pull the cover straight off the wall. The lever usually comes off with it. Rub any leftover tape off the key with your thumb. Your switch is exactly as it was. Moving it to a new home? Stick the lever back with a fresh square of double-sided mounting tape.
If something is off
Safety: the cover goes on top of the existing frame. Don't remove the frame and don't cover a switch that is cracked or shows wires. Get that repaired first.